![]() ![]() Washer loses pressureLikely causeThere can be a number of problems that cause this symptom, such as a blocked nozzle or water inlet, inadequate water supply, air in the inlet water supply hose or the pump.How to avoidIf the pressure is pulsing it’s worth checking that the water supply is fully turned on and that the hose supplying the pressure washer is not squeezed or kinked first. If your pressure washer has storage slots for the lance and nozzles, use these when you are cleaning instead of propping the lance on the floor. However after about 6 uses the pump lost pressure and vibration. Built in detergent dispenser is useless with the supplied lance. On first use this unit seemed to have a reasonable performance, though the supplied lance is awkward to use. Lance failsLikely causeIf there’s no water coming out of the lance it might be that the nozzle is blocked.If the lance itself is leaking this is probably due to splits in the plastic or failures of the seals caused by wear and tear.How to avoidAlways check that your lance and nozzles are assembled properly before turning on the trigger to avoid straining the seals between them.Avoid dropping your lance on the floor while you are using it and always check that the nozzles are free of debris. Written on: by stevensdrs (1 review written) Halfords HP2000 Has a sturdy casing and looks good. Do not allow your pressure washer to freeze by storing it in a frost-free place.It is possible to buy replacement parts for the plastic components and pumps of some pressure washers – check the manufacturer’s website for further details. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |